Bearing Inspection

  • This system is used to perform the inspection of bearings.
  • The system checks the presence & absence of the holes on
  • the bearing. It also checks the overall holes count on the bearing.
  • If there is no hole or less than the desired no. of hole is found then
  • that sample is rejected by the system.
  • The features of the system are:
  • Single Teledyne Dalsa BOA smart camera
  • Checks the holes inside the bearing.
  • Simple digital I/O result to the line PLC to ensure rejection of failed parts
  • Easy to modify vision configuration
  • Sensor can be run as a sensor with no operator input required
JoomShaper